Veteran

Education and Training

Florida State College at Jacksonville

2014 to Present

Major: Electrical Engineering

Associates Degree

Honors, Awards and Special Accomplishments

• Commanding Officer Letter Of Commendation
• Good Conduct Award
• Navy Achievement Medal

IEM Power Systems

October 2016 – Present

Wire/Electronics Technician

• Ran wires and terminated data connections. Performed installation of communications hardware such as switches, access points and firewalls.
• Servicing, repairing, calibrating, regulating, fine-tuning, testing machines, devices, and that operate primarily on the basis of electrical equipment
• Installed wires in accordance with electrical schematics, ensuring proper connectivity on multiple switchboard gears
• Effectively repaired or replaced defective components and wire installations were met through acceptable practices including splicing, and pinning of wiring.
• Installed wires and coaxial cables, CAT3 and Fiber Optic; Relocated, changed and removed equipment
• Read blueprints, schematics and floor plans
• Tested lines to determine malfunctions, using a variation of test equipment and trained new hires.

United States Navy Reserves

February 2015 – Present

Electronics Technician

• Operated and maintained electronic transmitting and receiving equipment, as well as digital and analog computers
• Monitored control system and stored software in secure locations
• Interpreted electric and electronic schematics and mechanical layouts to diagnose equipment problems
• Installed and maintained databases on Department of Defense Servers
• Collaborated with IT personnel with any networking issues such as printing and data access
• Obtained measurements and readings using volt and ohm meters, IC Testers and dial indicators
• Inspect television equipment for defects, safety hazards and complete necessary repairs
• Perform system diagnostic testing to identify, troubleshoot, and fix defective system components, including multi-pin and RF/coaxial connectors, as well as Category 5/twisted pair cables
• Configured mail processing network, including network switch and IP configurations
• Monitored LAN network environment including switches and software applications
• Performed installations and systems testing on naval shipboard vessels, airborne platforms, VLF, HF, VHF, and UHF radio communications equipment
• Install and maintained public address systems, radar equipment, earphone systems, intercom systems, electronic sirens, telephone systems, lighting stations, and other equipment and systems.
• Responsible for installing, administering and maintaining onboard communications and navigations systems.
• Install external antennas and cabling, repaired and maintained radio and multiplex equipment both analog and digital, and point to point communications systems.

United States Navy

July 2008 – June 2014

Mechanical Engineer/Maintenance Person

• Align fuel, water and air piping systems and control operation of diesel engines used for ship and small craft propulsion,
• Clean, lubricate, adjust, test and perform other preventive maintenance on diesel engines, reduction gears, air compressors, hydraulic or pneumatic clutches, steering engines and controllable pitch propeller systems;
• Operate and maintain desalinization plants used to make fresh water from sea water;
• Operate and service refrigeration plants and air conditioning systems; repairs on aircraft equipment and calibration of shipboard equipment
• Repair or replace valves, pumps, compressors, heat exchangers and control devices used with diesel engines and gas turbines; Make entries into and analyze machinery operating records and reports.
• Maintenance on multiple service diesel generators, high pressure air compressors, low pressure air compressors galley equipment, and air conditioning systems to ensure proper refrigeration was properly distributed
• Ensure fire pumps, distilled water system and reefer systems were operational for combat system tactics and navigational movements; interpret schematics, blueprints, assembly drawings and technical manuals.

• Prepared and installed proper lockout/tagout to protect work. Measured and fitted metal and/or resin chocks for large machinery such as generators, main engines, reduction and aircraft gears